Designed specifically for the fifth generation Camaro's hood lines and low pressure zones behind the radiator and above the wheel arches. This kit only includes a center section.
NASA Legal for ST2 area requirements.
Same product used on Russ Taylor's podium winning ST2 Z28 in NASA West Coast Championship.
This product does fit early 5G Camaro SS Hoods
- Optimized louver design to maximize extraction flow velocities within a vehicle in motion
- Reduces under hood pressure delta to reduce front end lift and increase net vehicle downforce.
- Significantly reduces under hood temperatures by extracting heat and allowing fresh cold air to enter the engine bay.
- Maximize life of engine accessories by reducing overall operating temperature.
- Increases dense, cold air flow through radiator to promote lower coolant temperatures.
- Louver backbone design maintains hood structural rigidity.
- Contoured to fit your specific hood curve.
- Installs easily with supplied templates.
- Included in kit: Templates for cutting, rivets, washers, and installation instructions for a factory quality installation.
- Powder coated Satin Black for clean appearance and durability.
Dimensions:
25.5" Height
20.5" Front Width
23.25" Rear Width
